Using Mach 4, hobby licence, version 4.2.0.4300.


G68 did work fine. Touch probe tested the degree, status line prompted it. G68 was in bottom statusline AND moving along in x I could see in DRA y slightly correcting the travel.

NOW this function is gone . G68 is promted after Probe, but no correction takes place. Even if I put in higher angles by G68 X0 Y0 R25 in MDI, there is no correction at all. G69 and G68 just switch in status line but no effect....

How to get G68 working again?

The first thing is to upgrade to the latest Mach4

https://www.machsupport.com/ftp/Mach4/DevlopmentVersions/Mach4Hobby_Installer-4.2.0.4740.exe