Hello everyone.
For Mach4, how do you do "Run From Here"?
When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.
Please tell me how to start at any position on the G Cord.
Please tell me in an easy-to-understand manner.

For Mach4, how do you do "Run From Here"?
When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.

It suppose that you are starting a new program from that line, if you are at feedhold you are not at start..

When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.

You need to be in idle mode to use "Run From Here".

Answer Hello Greekart.
I clicked on the "Feed Hold" button propertues.
It was in the state of the photograph, but it does not improve.
Please tell me the solution.

Not for the feed hold button..

Just stop running any file, select a line you want to start and press run from here.

Yes.
I know how to do that.
in short,
1, Stop
2. Put a line in Line.
3, rotate the spindle.
4, Cycle Start

・ For Mach3
1, Feed Hold
2, designation of arbitrary line
3, Cycle Start

Does Mach4 not work in the flow of 1, 2 and 3 like Mach3?

・ For Mach3
1, Feed Hold
2, designation of arbitrary line
3, Cycle Start

Does Mach4 not work in the flow of 1, 2 and 3 like Mach3?

I don't see the point for that and i never had try it.
Change the enable state of "Run from here" to enable always and give a try if it will work.
Mach4 when feedhold is just paused, you can't do much in that state, no motion e.t.c.