Hello Guest it is December 04, 2021, 01:08:05 PM

Author Topic: Mach3 Kernel Speed Problems  (Read 232 times)

0 Members and 1 Guest are viewing this topic.

Mach3 Kernel Speed Problems
« on: July 27, 2021, 12:32:40 AM »
Hey Folks,

Thanks in advance for your help.

I'm trying to increase the max speed of my CNC. After increasing the kernel speed and restarting Mach3, my top speed in motor tuning settings remains constant (around 1.4 m/min). Am I missing something here?

Offline ZASto

*
  •  387 387
    • View Profile
Re: Mach3 Kernel Speed Problems
« Reply #1 on: July 27, 2021, 01:21:36 AM »
Increase speed in motor tuning.
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Re: Mach3 Kernel Speed Problems
« Reply #2 on: July 30, 2021, 10:06:47 PM »
No, I mean that AFTER changing kernel speed and going to motor tuning, the maximum motor speed that I am able to set in the software remains the same. After restarting.

Offline Tweakie.CNC

*
  • *
  •  8,865 8,865
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach3 Kernel Speed Problems
« Reply #3 on: July 31, 2021, 12:31:59 AM »
Do you have a Mach3 license or are you operating in Demo mode ?
KEEP SAFE !

Offline ZASto

*
  •  387 387
    • View Profile
Re: Mach3 Kernel Speed Problems
« Reply #4 on: July 31, 2021, 01:59:52 AM »
As Tweakie wrote, demo mode is limited to 25kHz.
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Re: Mach3 Kernel Speed Problems
« Reply #5 on: July 31, 2021, 04:28:23 PM »
It's not a demo mode problem. I have a license. And the kernel speed is able to increase. Just not the motor speed.