Hi,
I can't really understand the point of this thread......THC is a realtime hardware thing not Gcode at all.
It's true that Fusion 360 post generates Gcode from the Fusion tool path...but what Gcode command says 'Go up a little' or 'Go down a little'.....there is no such
Gcode instruction, and even if there were all Gcode instructions have to pass through the motion buffer, easily 100ms delay. That's not THC, THC is, or needs to be, realtime or close
to it.
Also this board is about Mach4....its not really about Autodesk software. All the excerpts that have been posted in this thread are from Autodesk's post processor which
is in C# if I understand it correctly....it's got nothing to do with New Fangled Solutions software at all. No doubt Mach4 users whom also use Fusion (as I do) am interested in Fusion posts
and so its not unreasonable to post on this board.......but strictly speaking this is not a Mach4 issue at all.
The ESS supports THC, in particular it supports the WarpRunner board, and that board is similar to the TMC board that precedes it. With the WarpRunner board and the plugin recommended
for it by Warp9 then THC works just fine.
Craig