Hello Guest it is May 23, 2025, 07:42:26 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: How to make a tapered thread with Mach4?  (Read 6611 times)

0 Members and 1 Guest are viewing this topic.

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: How to make a tapered thread with Mach4?
« Reply #10 on: February 08, 2021, 01:08:57 PM »
Well it is not as hard as you think.. This is from the manual
R: Taper amount in the X axis, specified in radius. If omitted or 0 is specified a straight thread
will be cut.


Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline daniba73

*
  • 288 288
Re: How to make a tapered thread with Mach4?
« Reply #11 on: February 08, 2021, 01:11:38 PM »
OK thanks!
I'll try as soon as possible and I'll let you know!
Logged

Offline daniba73

*
  • 288 288
Re: How to make a tapered thread with Mach4?
« Reply #12 on: February 28, 2021, 05:25:54 PM »
In the end, I succeeded.
I had to use the method shown on page 32.
the code is G32.
it took me some time to write the gcode, but it doesn't matter.
thank you!
Logged
Pages: « 1 2   Go Up
« previous next »