ok, then try this:
see if the "G-Code" IsLoaded() LED is on, AND the M01 LED optional stop is On, AND if the IsMoving is NOT on.
Also, see if the "Cycle Start" LED is also on....... this would give you:
I have G-code that is currently executing, I have the M1 option turned on, and if the machine pauses while running the
g-code then, that would most likely be a G pause condition.
If that all fails, I could try and write a down and dirty plugin that would get to the internal "Mach States", and post them,
to a User Defined LED.......... Kinda a loooonnngggg slide for a short gain.
Scott