hi all
finished my colcherster bantam conversion
all running fine and accurite,except threading
i have read up so much on this threading but still cannot get it running correctly
whats the point on a cnc lathe if you cannot screwcut
I have a fully licenced mach3
followed various guides,but when i check "use spindle feedback in sync mode"
it will go to start position start spindle but will not screw cut,when i uncheck "use spindle feedback in sync mode" it will go to start position start spindle but will screw cut but out of pitch every pass
no backlash on ball screws,index counts rpm spot on,X and Z axis are calibrated and accurite ,ive been trying now for weeks with no joy
cannot figure it out