Hello Guest it is March 05, 2021, 03:44:53 PM

Author Topic: Sheetcam/Mach 3  (Read 5861 times)

0 Members and 1 Guest are viewing this topic.

Sheetcam/Mach 3
« on: October 03, 2007, 06:01:43 PM »
I am setting up sheetcam to use with mach3 for my plasma table.   After selecting mach plasma for the post processor, It then asks for G-code extention.  Sheetcam is defaulted to .tap extention. Is this correct or does it need changed to one of the other extentions?

Offline Hood

*
  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: Sheetcam/Mach 3
« Reply #1 on: October 04, 2007, 03:33:59 PM »
.tap should work just fine.
Hood