Hello Guest it is May 30, 2024, 04:06:15 PM

Author Topic: Motion Controller  (Read 1129 times)

0 Members and 1 Guest are viewing this topic.

Motion Controller
« on: September 18, 2020, 12:25:44 PM »
I know there is been some discussion on the UC300 controller but I am having problems getting the motors to run on mach3. The inputs are all working properly so I know communication is working. I believe that I do not have the ports and pins configued properly. I set them like the manual showed. I am using xp. Can anyone tell me which port and pins I should be using? Any help would be appreciated. This is the usb controller.

Offline TPS

  •  2,506 2,506
    • View Profile
Re: Motion Controller
« Reply #1 on: September 24, 2020, 02:42:16 PM »
btw in this Picture you can see, that they are using a Mach3 cracked licence.
we will not Support pirate licences.

@Tweakie, PLS lock this thread.
Thank You
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.