Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bobbya47 on September 18, 2020, 12:25:44 PM

Title: Motion Controller
Post by: bobbya47 on September 18, 2020, 12:25:44 PM

I know there is been some discussion on the UC300 controller but I am having problems getting the motors to run on mach3. The inputs are all working properly so I know communication is working. I believe that I do not have the ports and pins configued properly. I set them like the manual showed. I am using xp. Can anyone tell me which port and pins I should be using? Any help would be appreciated. This is the usb controller.

Title: Re: Motion Controller
Post by: TPS on September 24, 2020, 02:42:16 PM

btw in this Picture you can see, that they are using a Mach3 cracked licence.
we will not Support pirate licences.

@Tweakie, PLS lock this thread.
Thank You