Hello Guest it is March 28, 2024, 02:27:16 PM

Author Topic: usb motion controller board  (Read 2343 times)

0 Members and 1 Guest are viewing this topic.

Re: usb motion controller board
« Reply #10 on: October 13, 2020, 03:45:30 PM »
yes
did you ever figure out why your stb5100 was crashing at the end of a move in mach3?
i've been struggling with this for way too long. about to buy a different board.
I upgraded from the stb5100 to the pokeys57. the difference in quality is greater than the difference in cost. though it is super difficult to figure out the pokeys pins! ha!