Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Beebee on April 04, 2006, 04:21:00 PM
-
Hi
Could someone provide some additional details for the procedures necessary to use the teach wizard.
Someone in a forum far far away mentioned that you can just jog the machine to locations on the
table and basically run a piece. How do you enter each location. And is it necessary to know alot of
G-code. Basically I don`t have a clue how to get started with the wizard.
Beebee
-
I will be making a video of how to use the wizard once I have the new test mill up and running... But for now there is a thread on there that will show you how to get started.
Check this out:
http://machsupport.com/forum/index.php?topic=63.0