Hello,
I'm using the PoPendant in Mach4 and it is working good. I do have one problem when using the pendant. While using the pendant, Mach4 disables all the buttons in File Operations, Run Ops, and Cycle Start. I don't have a problem with that disabling the buttons, except for an example, when I'm running a Drill gcode file. I do manual tool changes. So, I have to use the pendant to lower the Z axis near the work surface and then zero the Z axis. When I do this, the only way to get the Cycle Start to work, I have to click on Enable/Disable button. When I do that, the drill gcode file resets back to the beginning. Then, I have to find where the program left off and use the button Run Gcode from Here.
Is there a way to stop Mach4 from disabling these buttons while using the pendant?
Thanks,
Kerry