Hello Guest it is November 14, 2024, 10:00:48 PM

Author Topic: end of career and mach3  (Read 2111 times)

0 Members and 1 Guest are viewing this topic.

end of career and mach3
« on: February 02, 2020, 07:47:18 AM »
Hello friends, I recently bought a cnc, I have a problem with mach3 when I refer the engines to zero the engines do not stop and it's time to hit the emergency button. I thought they were the end of career sensors, but when I move the machine with the keyboard to the limits if the sensors are activated, it only happens when I give it all the axes to zero. why is this happening?

Offline ZASto

*
  •  426 426
Re: end of career and mach3
« Reply #1 on: February 02, 2020, 08:58:03 AM »
How are configured your limit/home switches in Ports&Pins?
Something like this:
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Re: end of career and mach3
« Reply #2 on: February 02, 2020, 11:15:44 AM »
hi no I only have home limits checked not the +++ and -- but the home buttons are set the same
Re: end of career and mach3
« Reply #3 on: February 02, 2020, 12:55:04 PM »
should I check the +++ and the ---- boxes aswell ????
Re: end of career and mach3
« Reply #4 on: February 02, 2020, 02:16:04 PM »
thanks for answering, my board is an mks-v in the attached image is how I have it configured
Re: end of career and mach3
« Reply #5 on: February 02, 2020, 03:51:28 PM »
yes this as mine is set in ports and pins