Hi there
I have Mach4 and a UB1 board with UC300ETH.
I had previously operated with UCCNC and ran very well, including XHC Hb04.
Now with mach 4 I can't get the HB04 to work and Mach4 always forgets the settings for inputs and outputs. After each switch off I have to re-enter the values.
Can someone tell me why.

Best wishes
Torsten

Hi,

XHC have never made a plugin that adapts their pendant/pendants to Mach4. The only plugin/plugins have been
written by users who have shared their efforts. XHC have declined to have any involvement, to be honest XHC is rubbish,
their Mach4 ready motion controller is that buggy no-one uses it, and XHC don't care.

Craig