Hello Guest it is September 20, 2024, 05:35:17 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: MACH 4 LATHE POST  (Read 5257 times)

0 Members and 1 Guest are viewing this topic.

Offline gabedrummin

*
  • 117 117
MACH 4 LATHE POST
« on: January 19, 2020, 09:53:55 PM »
Wondering if anyone has made programs with Mastercam for Mach4 4 lathe ? What post do you use ?
Logged

Offline smurph

*
  • *
  • 1,550 1,550
  • "That there... that's an RV."
Re: MACH 4 LATHE POST
« Reply #1 on: February 02, 2020, 05:57:34 PM »
It should work with any Generic ganuc post.  We support both the single line and double line formats of G76.

Steve
Logged
Pages: 1   Go Up
« previous next »