Hello Guest it is May 05, 2025, 01:00:08 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: CNC4PC C10-BDBB  (Read 9367 times)

0 Members and 1 Guest are viewing this topic.

Offline whizzo

*
  • 8 8
CNC4PC C10-BDBB
« on: September 15, 2007, 11:11:09 AM »
Dear All,
            My first post on this forum  :)   I have been looking at Mach2/3 for some time now and I have been asked to retrofit a Bridgeport Series 1 CNC which has big stepper motors on it. The board mentioned above from CNC4PC claims it is capable of using pins 2 thru 9 as inputs. Does Mach 2/3 support this board ?

                                            Thanks in advance,

                                             David Winter.
Logged

Offline poppabear

*
  • *
  • 2,235 2,235
  • Briceville, TN, USA
Re: CNC4PC C10-BDBB
« Reply #1 on: September 15, 2007, 03:08:16 PM »
Yes, I use his boards they do well. BUT, note the bi directional is NOT isolated.
Logged
fun times

Offline whizzo

*
  • 8 8
Re: CNC4PC C10-BDBB
« Reply #2 on: September 16, 2007, 05:29:37 AM »
Thanks for the reply Poppabear. Ithink I wasn't specific enough with my question though.
I probably should have said  " Does Mach 2/3 support this board using pins 2 thru 9  AS INPUTS ? "

                       Thanks again,

                       David Winter.

Logged
Pages: 1   Go Up
« previous next »