Hello Guest it is September 17, 2019, 09:14:44 AM

Author Topic: Jogging works fine, but X& Y axis linked when using MDI  (Read 35 times)

0 Members and 1 Guest are viewing this topic.

Jogging works fine, but X& Y axis linked when using MDI
« on: September 07, 2019, 02:18:16 PM »
Hello,
There have been many bugs, but this one is new today.

When I jog, everything works fine. When I enter Y1 from (0.000,0.000), machine goes to (-.4396,1). I ran it again and it ends up at (-.4318,1.0000).

When I enter X1, machine goes form (0,0) to (0,.024).

Why are X and Y linked?
Thanks,
Chris

Offline TPS

*
  •  1,388 1,388
    • View Profile
Re: Jogging works fine, but X& Y axis linked when using MDI
« Reply #1 on: September 08, 2019, 05:18:23 AM »
maybe G16 selected?
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Jogging works fine, but X& Y axis linked when using MDI
« Reply #2 on: September 08, 2019, 03:55:37 PM »
Good guess, but no, that did not fix it. Also, moving Y through MDI moves x value even when X axis is disabled, and X motor is disconnected.
 I'm using a Gecko 540 board, and UC100 USB to parallel port adapter.
« Last Edit: September 08, 2019, 04:03:06 PM by ohsnapfit »