Hello Guest it is April 04, 2020, 08:12:55 AM

Author Topic: Following errors with HiCON Integra  (Read 178 times)

0 Members and 1 Guest are viewing this topic.

Following errors with HiCON Integra
« on: July 18, 2019, 09:46:47 AM »
I continuously get a 'following error' message that disables the axis motor. This occurs an all 3 axes. I am using the Maxine AC servo drive with built-in encoders  with the HiCON Integra and the 7737 board.
Anyone have a fix for this issue?
Re: Following errors with HiCON Integra
« Reply #1 on: July 18, 2019, 03:19:24 PM »
I changed the gain for the encoders on my system from 1 to -1 and the gain on the control input from 1 to 2 because the pattern of the count numbers indicated that it was necessary. I also had to reduce the acceleration a bit. The following errors in the HiCON Config panel motors test section have disappeared.