Hello Guest it is April 20, 2024, 12:05:58 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Jogging works fine, but X& Y axis linked when using MDI  (Read 5105 times)

0 Members and 1 Guest are viewing this topic.

Offline ohsnapfit

*
  • 2 2
    • View Profile
Jogging works fine, but X& Y axis linked when using MDI
« on: September 07, 2019, 02:18:16 PM »
Hello,
There have been many bugs, but this one is new today.

When I jog, everything works fine. When I enter Y1 from (0.000,0.000), machine goes to (-.4396,1). I ran it again and it ends up at (-.4318,1.0000).

When I enter X1, machine goes form (0,0) to (0,.024).

Why are X and Y linked?
Thanks,
Chris
Logged

Offline TPS

*
  • 2,505 2,505
    • View Profile
Re: Jogging works fine, but X& Y axis linked when using MDI
« Reply #1 on: September 08, 2019, 05:18:23 AM »
maybe G16 selected?
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline ohsnapfit

*
  • 2 2
    • View Profile
Re: Jogging works fine, but X& Y axis linked when using MDI
« Reply #2 on: September 08, 2019, 03:55:37 PM »
Good guess, but no, that did not fix it. Also, moving Y through MDI moves x value even when X axis is disabled, and X motor is disconnected.
 I'm using a Gecko 540 board, and UC100 USB to parallel port adapter.
« Last Edit: September 08, 2019, 04:03:06 PM by ohsnapfit »
Logged
Pages: 1   Go Up
« previous next »