Hello Guest it is June 01, 2020, 04:27:39 PM

Author Topic: Noise and wrong movement of stepper motor on mach3  (Read 305 times)

0 Members and 1 Guest are viewing this topic.

Noise and wrong movement of stepper motor on mach3
« on: May 11, 2019, 01:02:49 PM »
Hi
I am new to cnc router. I have completed one small project but now after that i am facing noise issue from stepper motor and my Y axis is not working in correct direction as earlier. It is going to y+ and y-  coardinate with one left arrow key.
I am using Windows xp sp3.
Please advise. Thanks

Offline reuelt

*
  •  439 439
    • View Profile
Re: Noise and wrong movement of stepper motor on mach3
« Reply #1 on: May 11, 2019, 04:27:16 PM »
You can change the direction by ticking or unticking "DirLowActive" in ports and pins | Motor output.
(see attached)
"the gift of God is eternal life through Jesus Christ our Lord"

Offline RICH

*
  • *
  •  7,409 7,409
    • View Profile
Re: Noise and wrong movement of stepper motor on mach3
« Reply #2 on: May 12, 2019, 08:20:12 AM »
i am facing noise issue from stepper motor

Newbie, ;)
Drives and motor tuning need to be set properly.  The noise will go away.
Do some reading on the basics.

RICH

Offline reuelt

*
  •  439 439
    • View Profile
Re: Noise and wrong movement of stepper motor on mach3
« Reply #3 on: May 13, 2019, 01:50:12 AM »
Hi
I am new to cnc router. I have completed one small project but now after that i am facing noise issue from stepper motor and my Y axis is not working in correct direction as earlier. It is going to y+ and y-  coardinate with one left arrow key.
I am using Windows xp sp3.
Please advise. Thanks

Could you print screen your motor-tuning page for Y-axis paste in paint save as a PNG file and upload here.
We also need to know your stepper driver model and your Break out board model and your power supply model.
"the gift of God is eternal life through Jesus Christ our Lord"