Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: asif302 on May 11, 2019, 01:02:49 PM
-
Hi
I am new to cnc router. I have completed one small project but now after that i am facing noise issue from stepper motor and my Y axis is not working in correct direction as earlier. It is going to y+ and y- coardinate with one left arrow key.
I am using Windows xp sp3.
Please advise. Thanks
-
You can change the direction by ticking or unticking "DirLowActive" in ports and pins | Motor output.
(see attached)
-
i am facing noise issue from stepper motor
Newbie, ;)
Drives and motor tuning need to be set properly. The noise will go away.
Do some reading on the basics.
RICH
-
Hi
I am new to cnc router. I have completed one small project but now after that i am facing noise issue from stepper motor and my Y axis is not working in correct direction as earlier. It is going to y+ and y- coardinate with one left arrow key.
I am using Windows xp sp3.
Please advise. Thanks
Could you print screen your motor-tuning page for Y-axis paste in paint save as a PNG file and upload here.
We also need to know your stepper driver model and your Break out board model and your power supply model.