Hello everybody
Something odd happened to me:
Set and Goto variable position (in the MDI tab) do not work anymore:
X is fine, but Y and Z always want to go to the 0 machine coordinates.

I checked everything I could (macros and config) but everything seems to be ok.
I'm a bit lost...

any idea about the problem

Fred

Hello everybody
Something odd happened to me:
Set and Goto variable position (in the MDI tab) do not work anymore:
X is fine, but Y and Z always want to go to the 0 machine coordinates.

I checked everything I could (macros and config) but everything seems to be ok.
I'm a bit lost...

any idea about the problem

Fred

I am only guessing.
You are probably NOT at G54 offset (ie. Work Offset#1)?

I just found the issue
the macros were altered for a reason that remains a mystery...
I just copied all macros from a backup file and everything came back fine

thanks anyway !