Hello Guest it is January 28, 2020, 08:45:57 AM

Author Topic: Hicon integra synchronized threading with spindle encoder feedback  (Read 573 times)

0 Members and 1 Guest are viewing this topic.

hello experts.
The HiCON Integra motion controller supports full synchronized threading with spindle encoder feedback on mach3?
using G76 or G32 cycles.
 I have a ESS smoothstepper ethernet, but this card only supports single pulse index, works fine with short threads, but with long threads is not good.
thanks in anvanced.
luis.
Re: Hicon integra synchronized threading with spindle encoder feedback
« Reply #1 on: February 22, 2019, 12:35:25 PM »
Yes, the RPM is synched with the spindle encoder during threading.