I'm not getting it. I must have something in my Mach3 profile that is set incorrectly. Check out the GCode below. A follows X except when A is supposed to go to 1, it goes there the long way 2->360->1. It's like I can only go in the positive direction with A. I have "Rot 360 rollover" and "Ang Short Rot on A0" set in my general config.
G00 X1
G00 A1
G01 X2
G01 A2
G01 X1
G01 A1 (this goes from 2 to 359 to 1)
G01 X2
G01 A2