Hello
I noticed a particularity when using the G76 thread cycle.
Give an example
I do a thread at 800 RPM,
and then following various problems I decided to change the number of shifts from 800 to 400, I noticed that Mach4 no longer takes the correct step, so as to ruin the first cycle of passage.
is this condition for you too, or do I have the wrong settings?
I ask, because when I tried Mach3 Turn before using Mach4 Lathe, it seemed more stable in the thread, even though I changed the number of revolutions while running the loop did not ruin the thread.
this is the link to the video of when I tried Mach3 Turn threading and sync
https://www.youtube.com/watch?v=sZn3no2siA4thank you in advance for any reply!