Hello Guest it is June 23, 2024, 05:19:48 PM

Author Topic: Z moves up when uc100 disconnects  (Read 9887 times)

0 Members and 1 Guest are viewing this topic.

Z moves up when uc100 disconnects
« on: January 11, 2019, 08:43:58 AM »
I've had Uc100 for quite some time without any issues. Lately, I noticed that  the UC100 gives me a "disconnect" error with USB, which stops the job midway. If I disconnect the USB cable from the pc, the z axis starts moving up until I reconnect it again. Is there a way to prevent this in mach3 ? With the z axis moving up, I have no time to diagnose the problem, which forces me to turn off the entire system ans start all over again.

Offline ger21

  • *
  •  6,295 6,295
    • The CNC Woodworker
Re: Z moves up when uc100 disconnects
« Reply #1 on: January 11, 2019, 11:55:04 AM »
Once the UC100 is disconnected, the axis shouldn't be moving at all. Sounds like a serious noise issue is both causing the disconnect, and causing the Z axis motion?

2010 Screenset

JointCAM Dovetail and Box Joint software