Hello Guest it is March 28, 2024, 07:42:23 AM

Author Topic: Digispeed problem  (Read 749 times)

0 Members and 1 Guest are viewing this topic.

Digispeed problem
« on: January 15, 2019, 05:23:12 PM »
I have a strange problem, I have a Mini Mill X2 with a Digispeed DC-3 V3 to control my spindle, It had been working great, but today I found as soon as I start Mach3, my spindle starts up at full speed and can not be controlled. I have checked the configuration page and all is the same. The only way to stop the spindle is to either hit the E-Stop on the motor control or tick the Dir LowActive on the Motor Outputs  page of the Pins and Ports.

Any one have any suggestions?

Thanks for the help

Jziz