Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jziz on January 15, 2019, 05:23:12 PM
-
I have a strange problem, I have a Mini Mill X2 with a Digispeed DC-3 V3 to control my spindle, It had been working great, but today I found as soon as I start Mach3, my spindle starts up at full speed and can not be controlled. I have checked the configuration page and all is the same. The only way to stop the spindle is to either hit the E-Stop on the motor control or tick the Dir LowActive on the Motor Outputs page of the Pins and Ports.
Any one have any suggestions?
Thanks for the help
Jziz