I configure it in the tools menu and press enter. If I recall the tools menu the configuration is set back to 'T on M6 line is next tool'. Also it works so.
My Logfile shows:
2018-11-14 10:16:09.029 - Logging Enabled.
2018-11-14 10:16:15.404 - API: mcCntlConfigStart(inst = 0) (Mach4GUI)
2018-11-14 10:16:15.404 - Attempt transition from "Idle" on event "Config" MachAPI.cpp:3622
2018-11-14 10:16:15.404 - S_IDLE_on_exit
2018-11-14 10:16:15.404 - ACTION_start_config
2018-11-14 10:16:15.404 - S_CONFIG_on_entry
2018-11-14 10:27:43.855 - API: mcCntlConfigStopEx(inst = 0, reload = 0) (Mach4GUI)
2018-11-14 10:27:43.855 - Attempt transition from "Config" on event "Stop Config" MachAPI.cpp:3652
2018-11-14 10:27:43.855 - S_CONFIG_on_exit
2018-11-14 10:27:43.887 - ACTION_stop_config
2018-11-14 10:27:43.887 - S_IDLE_on_entry
--------------------------------------------------------
I am running version 3893. I run 3835 before with same problem and hopped, installing the latest version would solve my problem.
Is there any other setup which influences this config part? What cold be the reason for this misbehavior.
Regards,
Karl