Brian, I am working on this project in a couple of places, on the machine I use at Home which is networked with work and accesses the same Mach DIR XML etc I get the Macropump Thread dummy pop-up, but on my system at work I dont get the popup. I am trying to test out the input configuration etc, I have this in my macropumo code to mintor Inoput and set an LED in response to an INPUT The Output 1 get activated on a Software ESTOP but that is about the only thing that happens.....I have never had much luck with inputs, my own system has the triggers assigned to buttons and not using the macropump as I could never get it to work..... so any pointers would be appreciated....
Mike
[ Macropump code ]
ES=GETLED(0)
If ES=True Then
ACTIVATESIGNAL(OUTPUT1)
Else
DEACTIVATESIGNAL(OUTPUT1)
END IF
IN_LED1=ISACTIVE(EMERGENCY)
IN_LED2=ISACTIVE(INPUT1)
IN_LED3=ISACTIVE(INPUT2)
IN_LED4=ISACTIVE(INPUT3)
IN_LED5=ISACTIVE(OEMTRIG1)
IN_LED6=ISACTIVE(OEMTRIG2)
IN_LED7=ISACTIVE(OEMTRIG3)
IN_LED8=ISACTIVE(OEMTRIG4)
IN_LED9=ISACTIVE(OEMTRIG5)
IN_LED10=ISACTIVE(OEMTRIG6)
IN_LED11=ISACTIVE(OEMTRIG7)
IN_LED12=ISACTIVE(OEMTRIG8)
IN_LED13=ISACTIVE(OEMTRIG9)
IN_LED14=ISACTIVE(OEMTRIG10)
IN_LED15=ISACTIVE(OEMTRIG11)
IN_LED16=ISACTIVE(OEMTRIG12)
SetUserLED(1201,IN_LED1)
SetUserLED(1202,IN_LED2)
SetUserLED(1203,IN_LED3)
SetUserLED(1204,IN_LED4)
SetUserLED(1205,IN_LED5)
SetUserLED(1206,IN_LED6)
SetUserLED(1207,IN_LED7)
SetUserLED(1208,IN_LED8)
SetUserLED(1209,IN_LED9)
SetUserLED(1210,IN_LED10)
SetUserLED(1211,IN_LED11)
SetUserLED(1212,IN_LED12)
SetUserLED(1213,IN_LED13)
SetUserLED(1214,IN_LED14)
SetUserLED(1215,IN_LED15)
SetUserLED(1216,IN_LED16)