Hello Guest it is December 02, 2022, 12:24:13 PM

Author Topic: HiCon Plug Crash  (Read 1589 times)

0 Members and 1 Guest are viewing this topic.

Offline Boots

  •  17 17
    • View Profile
HiCon Plug Crash
« on: October 06, 2018, 05:53:53 PM »
Install Hicon Intergra 7766 with 7377 Hicon plugin crash

System: Dell Precision, Windows 7, 7766, 7377 boards, Mach4 install

When I try to configure HiCon Device (Config>Select Motion Device) it comes up with an error: Config Data not Initialized or Corrupt. Then in goes to the Dos screen and says "Configuration Download Success" Then it closes Mach4.

When I Re-start Mach4 and run VSI Device Manager and then San the Network is shows the correct IP connection. HiCon is also shown in the window below. I also enabled "J7 step and Direction" and clicked Download. But it still crashes.  ???

?? Could uses some help, Boots-2b1