Hi all,
I have been using Mach3 for 6 years now and have had no big troubles with it, all has worked well with a little help from the manual or by reading others questions and answers. But 2 weeks ago, I change the motor drivers of my CNC router and also made a change from inches to millimeters in my configuration, and now I am having a very confusing trouble....
I calculated and configured my steps per unit and the machine is acting very strange, you will see, to fine tune the steps, I have sent to cut 6 small squares of 10, 20, 30, 40, 50 and 60 mm but the smaller ones are cut a little small and the bigger ones are cut bigger and bigger. Below you will find a small table with the measurements I have got in my last attempt to calibrate.
Sent square Dim X Dim Y
10x10 9.89 9.89
20x20 19.92 19.97
30x30 29.93 30.08
40x40 39.98 40.1
50x50 50.03 50.25
60x60 60.15 60.3
As I understand, all the measurements should be smaller or bigger by the same proportion (or ideally, correct!), but I am having some small and as the piece gets bigger, then the measurement is bigger and bigger......
If i adjust the steps per unit to obtain a 10 mm cut from a 10 mm drawing or gCode instruction, all the rest of the squares are each one bigger than the previous an the same happens inversely, if I adjust to get a 60 mm cut from a 60 mm gCode, all the rest of the squares are each one smaller than the previous one and if I adjust to get a 30 mm cut from a 30 mm gCode, the smaller cuts are increasingly small and the bigger ones are increasingly big
I have double and triple checked the diameter of the endmill, I have used Aspire to generate the gCode an have write it by myself, and made any other kind of revisions and the results are always the same and consistent, I really hope that someone could help me sending some light in this confusing results.
Thank you for your time and knowledge!!!