Hi,
more important than speed is acceleration.
If you had some Gcode that makes an axis go backwards and forwards at maximum acceleration.
Then up the acceleration in Machs motor tuning and do it again. Keep upping the acceleration until
you get an overcurrent fault from the Gecko. Back off the max acceleration by about 25%.
Is your machine in inches or metric? How long are the axes?
If in inches I'd try something like:
G0 X4
X0
X4
X0
X4
X0
X4
X0
X4
X0
Which will make the X axis go backwards and forwards by 4 inches as fast as it can, up to the max velocity
you have set. What you are hoping is that the axis is still accelerating by the time it has to start slowing down
again, ie it never gets to Vmax but is in a reversing but maximum continous acceleration phase.
Craig