Hello Guest it is April 12, 2021, 08:24:13 PM

Author Topic: RefAllHome issues  (Read 736 times)

0 Members and 1 Guest are viewing this topic.

RefAllHome issues
« on: August 13, 2018, 05:32:53 PM »

I have a couple of issues with zeroing my CNC;

1/ When i RefAllHome with the Y axis it slows down, goes to zero then Y5 & then goes the opposite direction it should go ie. away from the home switch... forever(?)
If i change the motor tuning acceleration to 80 (from 400) it works as it should- but it's frustrating having to do this & back again every time.

2/ When i run G28.1 X10Y10Z10 from MDI it works fine. When i put this into a gcode & run it repeats itself over & over - is there a way to tell it to stop?


Re: RefAllHome issues
« Reply #1 on: August 13, 2018, 09:05:49 PM »
the direction ans speed that an axis attains during homing is set on Config/Homing and Limits page.
The speed is a percentage of G0 speed, commonly 20%

My wife left with my best friend...
     and I miss him!