Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: boom-shanka on August 13, 2018, 05:32:53 PM

Title: RefAllHome issues
Post by: boom-shanka on August 13, 2018, 05:32:53 PM
Hi

I have a couple of issues with zeroing my CNC;

1/ When i RefAllHome with the Y axis it slows down, goes to zero then Y5 & then goes the opposite direction it should go ie. away from the home switch... forever(?)
If i change the motor tuning acceleration to 80 (from 400) it works as it should- but it's frustrating having to do this & back again every time.

2/ When i run G28.1 X10Y10Z10 from MDI it works fine. When i put this into a gcode & run it repeats itself over & over - is there a way to tell it to stop?


Cheers

Title: Re: RefAllHome issues
Post by: joeaverage on August 13, 2018, 09:05:49 PM
Hi,
the direction ans speed that an axis attains during homing is set on Config/Homing and Limits page.
The speed is a percentage of G0 speed, commonly 20%

craig