Hello Guest it is May 11, 2021, 03:52:52 PM

Author Topic: Problem with Mach4 Boss Probing  (Read 507 times)

0 Members and 1 Guest are viewing this topic.

Problem with Mach4 Boss Probing
« on: July 03, 2018, 03:18:05 PM »
Hi,

I’m trying the boss probing in Mach4 (Probing->Boss/Bore) but I don’t get it to work correctly. It seams that I miss the center of the boss I’m measuring with about the radius of my probe.

The bore probing is working fine and I get correct values. The probe is calibrated under the Calibration tab, with a calibration ring (known diameter).

Anybody else that have experienced problem with the “boss probing”, I can’t find anything about that in the forum.   

Best Regards,
Kjell