Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Olovsson on July 03, 2018, 03:18:05 PM
-
Hi,
I’m trying the boss probing in Mach4 (Probing->Boss/Bore) but I don’t get it to work correctly. It seams that I miss the center of the boss I’m measuring with about the radius of my probe.
The bore probing is working fine and I get correct values. The probe is calibrated under the Calibration tab, with a calibration ring (known diameter).
Anybody else that have experienced problem with the “boss probing”, I can’t find anything about that in the forum.
Best Regards,
Kjell