Hello Guest it is October 21, 2019, 05:33:40 PM

Author Topic: How to handle the Tool height Probe sensor  (Read 443 times)

0 Members and 1 Guest are viewing this topic.

How to handle the Tool height Probe sensor
« on: May 01, 2018, 12:49:29 PM »
Hi there
I am trying to use a probe sensor in order to set the tool height in my Tool bank, how this can be done?
Do I have to run this macro right after my m6 Macro?
Also how can I update my Tool Bank, after any reading of the tool height?
Finally any advice on the macro codes is really appreciated
Regards
Jhonansaro