Author Topic: UC100 problem  (Read 859 times)

0 Members and 1 Guest are viewing this topic.

Offline jganley

  • Active Member
  • Posts: 9
    • View Profile
UC100 problem
« on: April 16, 2018, 10:28:29 AM »
I am using a HobbyCNC EZBoard with the UC100 and Mach3 Software, I cannot get the Y Axis to work I have swapped motors around and they (motors) are good. When I turn on the controller all motors lock (for better word) including the Y Axis the UC100 has a steady green and blue light has anybody had troubles with the UC100?