Hello Guest it is December 07, 2021, 10:55:23 PM

Author Topic: Teknic Clearpath Servo setting for Mach3  (Read 3725 times)

0 Members and 1 Guest are viewing this topic.

Re: Teknic Clearpath Servo setting for Mach3
« Reply #10 on: January 13, 2020, 06:36:32 AM »
I have used them on a number of machines. Check out using the HLFB signal in "Servo On" mode and use that signal, when active to operate a limit type operation. Don't now how inputs can be configured in Mach, but with WinCNC I am able to halt motion.