Hello Guest it is January 27, 2023, 09:53:09 AM

Author Topic: "Ref all home" sets wrong coordinates (XHC MKX-IV control card)  (Read 5260 times)

0 Members and 1 Guest are viewing this topic.

Offline Olavi

*
  •  13 13
    • View Profile
Re: "Ref all home" sets wrong coordinates (XHC MKX-IV control card)
« Reply #10 on: January 31, 2022, 02:00:27 AM »
I run cnc on single drive until now. There was several reason why it took so long. But I have to say it worked, but there was serious resonances at specific speeds. Also it was possible that CNC machine didnt stop in case one of one motor stopped working by some reason.

Now we have 2 drives again and machine is working fine.

Thanks for answers and recommendations.