everything seems ffine to me,..,
N0010 (Filename: 1.tap)
N0020 (Post processor: Mach3 plasma.scpost)
N0030 (Date: 28/02/2018)
N0040 G20 (Units: Inches)
N0050 G53 G90 G91.1 G40
N0060 F1
N0070 S500
N0080 (Part: 1)
N0090 (Operation: Outside Offset, LAYER_1, T1: Plasma, 0.0561 in kerf)
N0100 M06 T1 F80.0 (Plasma, 0.0561 in kerf)
N0110 G00 Z1.0000
N0120 X0.6134 Y0.6013
N0130 Z0.0000
N0140 M03
N0150 G03 X0.7726 Y0.6873 I0.0366 J0.1227 F80.0
N0160 X0.7726 Y0.6873 I-0.2726 J0.0813
N0170 X0.6865 Y0.8466 I-0.1227 J0.0366
N0180 M05
N0190 G00 Z1.0000
N0200 X1.1256 Y-0.1384
N0210 Z0.0000
N0220 M03
N0230 G03 X0.9976 Y-0.0104 I-0.1280 J0.0000
Hmm, N0100 & N0130 items seem odd to me
Tool change is not usually used in plasma, why is it going to Z0 before the pierce??
You should never, pierce at zero height, unless this is a scratch-start plasma??