Hello Guest it is April 17, 2021, 12:19:37 AM

Author Topic: Mach3 for Large CNC Router Table - or Not?  (Read 3953 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  8,695 8,695
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach3 for Large CNC Router Table - or Not?
« Reply #20 on: June 24, 2018, 01:52:34 AM »
Going a bit off topic but when Art wrote the Tempest planner and incorporated it into Mach Quantum I think he expected it would migrate into Mach4. Unfortunately it never happened but it was a good product and Art then went on to use Tempest in his current laser control software Auggie.
When I use machine control software incorporating the ‘S’ curve acceleration / deceleration it makes me wonder just how the ‘bang-bang’ trapezoid system has been accepted for so long.

Tweakie.
KEEP SAFE !