Hello Guest it is May 11, 2021, 07:36:55 PM

Author Topic: Toolpath Display  (Read 1095 times)

0 Members and 1 Guest are viewing this topic.

Toolpath Display
« on: October 09, 2017, 11:37:41 AM »
Hello!  We are running a plasma table with sheetcam/mach3.  Our first computer died last month and we have since purchased a new one and loaded a new copy of mach onto it. Whenever we loaded a file into mach with our old computer, the image was large, clear and we could easily watch the toolpath....we never had to zoom in. From the beginning with our new computer, the image has appeared miniscule. We can zoom in and it looks ok, but still not as clear as we previously had it. We'd just like to find a default setting to make the image populate the toolpath display the same way it did before. Any help is much appreciated!
Re: Toolpath Display
« Reply #1 on: October 09, 2017, 01:42:29 PM »
Hi,
sounds like the toolpath is being drawn in the wrong units. Is your Gcode drafted in inches or mm?

Craig
My wife left with my best friend...
     and I miss him!