Another dumb question .
I come to start my computer this morning and I thought to check my motor tuning. What do you know , but my pulse width has reset to 0 uS. Well, perhaps I did not save the settings , so I do this. Then I thought: I will test this out. So I restart my computer and and check my pulse width again and it has reset to 0 uS. Now i must be getting old, grumpy and suspicious. I check out all the changes Tweakie recommended and they have all changed back to the old settings. I am now just as old but more grumpy and suspicious.
So I reset all the changes back to Tweakia's and I start to restart my computer. This takes a little long to do, so, rather than restart , I shut down Mach 3 and reopen it. Now all the changes remain correct. So I then restart my computer, now everything remains correct.
I am now old , grumpy suspicious and baffled!
Is there a proper procedure to make sure all settings are saved.
One thought occurs to me: last night I left the workshop in a hurry. I just flipped all the switches off on the power board, didn't shut Mach 3 down or the computer.