Hello Guest it is October 14, 2019, 02:39:06 AM

Author Topic: Mach 3 installation  (Read 522 times)

0 Members and 1 Guest are viewing this topic.

Mach 3 installation
« on: August 14, 2017, 11:10:35 AM »
Hi All

I have retrofitted my Morbidelli machine with a c-s Lab controller which I intend to run on Mach3, I have done all the installation of the hardware components (relays, controller, encoders etc) I was working with an engineer however he wont commit to completing the installation as I paid a nominal fee for the guidance, 50% up front and 50% when completed. First bit went fine, however he seems to know less than me about the MACH3 programme and avoids clarification as to when he will be coming over to the uk (he is European). As a novice with this programme I could master it but will take me considerably longer to do so. Does anyone know of anyone in the UK who could install and set up the machine as I work full time and I am struggling to find time to undertake.

Any help would be appreciated.

Thanks Stuart
Re: Mach 3 installation
« Reply #1 on: August 14, 2017, 05:06:31 PM »
I went to these guys for help with Mach3, albeit they didn't reply (I only sent one email and haven't chased them).  http://www.routoutcnc.com
Based in Leicestershire.  Maybe give them a try