Hello Every one
I'm hoping some one could help me. My tool height sensor was working perfectly for over 8 months. then one-day it decided to stop working (whilst making a very expensive table top) it preceded to not earth out the probe and so the machine did not stop a drove the tool deep in the the sensor and then in to the the table top.
I have checked the wiring and all is fine so im not sure if its a problem with the break out board or a software problem with Mach3?
Has any one experienced this before? I can see on the diagnostics page that nothing is registering when i touch on the tool with the sensor.
Any help would be much appreciated
Thanks
Nick