Hi, will a pc that is possibly failing cause my machine to home but not jog.
I have been away from my router table for a while busy with other projects
Last week I was attempting to flash it up again to begin cutting again.
On start up Mach 3 indicates that the drivers were successfully installed. The motors locked in on power up but non of the axis will jog.
I did a reference all to home which the axis did, but then fails to jog once again.
While away from my machine. I had used its pc for some drawings and noticed on a few occasions that the pc failed to boot up. After a number of attempts to start the pc it did boot up and managed to complete my drawings.
If the pc is beginning to fail will this cause mach3 not to operate correctly.
The pc is a a refurbished unit, I bought some years back to act as stand alone control for the router table.
The only programmes beside xp are Mach3 and 1 drawing programme loaded onto it. It is not connected to the web or any network.