Hello Guest it is March 28, 2024, 08:23:31 AM

Author Topic: Can't open full gcode file in Mach 3.  (Read 1277 times)

0 Members and 1 Guest are viewing this topic.

Can't open full gcode file in Mach 3.
« on: May 27, 2017, 05:55:41 AM »
Hello Fellow Boffinators.

I am the proud new owner of a 2nd hand  4' x 4' Plasma table all set up and ready to go.
I seem to have developed a problem I can't cure.
Every file I download into Mach 3 is incomplete.
It used to work magnificently but I've pushed a button or done something and now Mach 3 is angry with me.
At the top it says licenced to "*********X ******************" so I assume the program is legal and fully functional.
When I check the code lines in notepad there are many more lines than what comes into Mach 3.
It doesn't seem to matter the source of the file, it still plays up. and gives me one small corner.

What would place a limit on the number of lines coming into Mach 3.

Nice program too by the way.

Cheers Phil
Re: Can't open full gcode file in Mach 3.
« Reply #1 on: May 27, 2017, 10:16:31 AM »
I was reading the "Hall of Shame" and it seems I have a Papa Fabio Fake licence. Hopefully, problem solved.